Abit BP6 - Celeron 400's- 500's
This is a discussion about Abit BP6 - Celeron 400's- 500's in the Windows Hardware category; How Stable is celeron 400's overclocked to 500mhz or higher on this board,,, has anyone done this? and how was it ,, must know fast ,, would like to buy a few of these setups (or should I). Thanks bigb.
How Stable is celeron 400's overclocked to 500mhz or higher on this board,,, has anyone done this? and how was it ,, must know fast ,, would like to buy a few of these setups (or should I).
Thanks bigb
Thanks bigb
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Feb 10
Feb 10
0
1 minute
Responses to this topic
I have an ABit BP6 with two cel400a's overclocked to 500MHz, i did have the up to 550, but i though i'd try to extend their lives. They're very stable as long as you have sufficient cooling.
[This message has been edited by EddiE314 (edited 10 February 2000).]
[This message has been edited by EddiE314 (edited 10 February 2000).]
I have a BP6 w/2 366. I run all the time at 500 (5.5 x 91 or 92mhz, don't remember) and have never had a problem. This FSB should allow a 1/3 multiplier on PCI bus so it still runs abit slower then 66mhz spec. I also have a V3-3K, SBLive, IntelEtherPro 100 and 192 mb PC100 ram. When I game, I bump it up to 550 (5.5 x100), which on occasion does crash, but not that often.
Good luck and check out www.bp6.com, nice site for BP6 owners.
-QAZ
Good luck and check out www.bp6.com, nice site for BP6 owners.
-QAZ
OP
How Much Cooling do you think i should put in there to really keep it down (heat) eddie
OP
[This message has been edited by bigb (edited 10 February 2000).]
