Building DMI Pool
This is a discussion about Building DMI Pool in the Windows Hardware category; I upgraded from a K7-650Mhz to a K7-750Mhz. Now I get the message Building DMI Pool. . . . . . . right after the bios boot up. And the system goes no further. When I plug my 650 back in the system boots up fine without this hang up.
I upgraded from a K7-650Mhz to a K7-750Mhz. Now I get the message Building DMI Pool....... right after the bios boot up. And the system goes no further.
When I plug my 650 back in the system boots up fine without this hang up. I have taken out all the peripheral devices. The only card in is the old PCI 2 meg vid card. I also tried disabling the CPU L1 and L2 cache. No luck. What can I do? Here are my system specs.
Abit KA7-100 with latest flash.(raid controller disabled, USB disabled)
AMD K7-750Mhz (7.5 x 100)
300W power supply
No hard drive plugged in. (boot from floppy)
No CD ROM
128Meg Infineon PC133RAM
When I plug my 650 back in the system boots up fine without this hang up. I have taken out all the peripheral devices. The only card in is the old PCI 2 meg vid card. I also tried disabling the CPU L1 and L2 cache. No luck. What can I do? Here are my system specs.
Abit KA7-100 with latest flash.(raid controller disabled, USB disabled)
AMD K7-750Mhz (7.5 x 100)
300W power supply
No hard drive plugged in. (boot from floppy)
No CD ROM
128Meg Infineon PC133RAM
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
