HD Tach 2.61 says CPU utilization at 56% , Could it be...
because im using a promise at-100tx2 controller card for both my HDs?
because im using a promise at-100tx2 controller card for both my HDs?
Participate on our website and join the conversation
This topic is archived. New comments cannot be posted and votes cannot be cast.
Responses to this topic
I'm using a Promise Fasttrak TX2 RAID Controller.
My CPU utilisation is around 6-6.5%.
http://www.prawlings.net/benchmarks/hdtach.htm
The above link is with HDTach 2.52 but 2.61 reported the same.
Maybe it is an issue with the standard Promise IDE controllers rather than the RAID ones.
My CPU utilisation is around 6-6.5%.
http://www.prawlings.net/benchmarks/hdtach.htm
The above link is with HDTach 2.52 but 2.61 reported the same.
Maybe it is an issue with the standard Promise IDE controllers rather than the RAID ones.
Ah yes, I am running the Promise drivers rather than those included in WinXP.
For the TX2 RAID controller these are 2.0.0.26
For the TX2 RAID controller these are 2.0.0.26
You might want to try sending Promise Tech support an e-mail.
I've had dealings with them in the past (Issues with a TX4 RAID controller) and they have always been very helpful - they actually do know what they are talking about.
I've had dealings with them in the past (Issues with a TX4 RAID controller) and they have always been very helpful - they actually do know what they are talking about.
