How to configure the B2C2 Broadband Receiver.
This is a discussion about How to configure the B2C2 Broadband Receiver. in the Windows Hardware category; I just installed the SkyStar 2 card first using the drivers on the CD and next using the drivers from and found no problems. and I found as a network adaptor B2C2 Broadband Receiver. Now I like to know how to configure the card in windows 2003 server in order to access the internet.
I just installed the SkyStar 2 card first using the drivers on the CD and next using the drivers from www.technisat.de and found no problems. and I found as a network adaptor B2C2 Broadband Receiver.
Now I like to know how to configure the card in windows 2003 server in order to access the internet .
I tried many ways ,but not able to access internet through this broad band receiver.when i see the status of the skystar properties ,it show that the signal is ok (9.3db)and I am getting green color status also from the receiver.
But when i try to open the internet,no page is displayed.
Pls help to get out of this problem.
Now I like to know how to configure the card in windows 2003 server in order to access the internet .
I tried many ways ,but not able to access internet through this broad band receiver.when i see the status of the skystar properties ,it show that the signal is ok (9.3db)and I am getting green color status also from the receiver.
But when i try to open the internet,no page is displayed.
Pls help to get out of this problem.
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Mar 16
Mar 16
0
1 minute
Responses to this topic
Do you get (valid) IP, dns, gateway addresses from your ISP?
Start->Run:
cmd
ipconfig /all
Start->Run:
cmd
ipconfig /all
