Parity error

This is a discussion about Parity error in the Windows Hardware category; I am reciving the following error: an error was detected on device\Device\Harddisk2\DR2 during paging operation. I also have another that I do not understand. A parity error was detected on \Device\Scsi\adpu160m.

Windows Hardware 9627 This topic was started by , . Last reply by ,


data/avatar/default/avatar15.webp

2 Posts
Location -
Joined 2004-10-18
I am reciving the following error: "an error was detected on device\Device\Harddisk2\DR2 during paging operation."
I also have another that I do not understand.
"A parity error was detected on \Device\Scsi\adpu160m."
 
Any help on these two issues would be greatly appreicated.
 
Thanks Woolly

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This subject has been archived. New comments and votes cannot be submitted.
Oct 18
Created
Oct 18
Last Response
0
Likes
1 minute
Read Time
User User
Users

Responses to this topic


data/avatar/default/avatar39.webp

1457 Posts
Location -
Joined 2001-12-18
Something is amiss with your hard drive. For whatever reason (and it may have something with burning a CD that had a buffer overrun) the Adaptec driver either got corrupted or something paged to the swapfile left an open pointer connected to the Adaptec driver.
Boot into safemode and run Chkdak first. If that doesn't cure it, see if you can first move the swapfile, erase the old one, then move it back. Finally, you may have some Ram going soft, so you might try some of the free software to test out your Ram.

data/avatar/default/avatar15.webp

2 Posts
Location -
Joined 2004-10-18
OP
Thank you very much I will try this.
I would still like other feed back to look at.
 
Thanks Woolly