Problems installing nt4.0 on a serial ata drive
This is a discussion about Problems installing nt4.0 on a serial ata drive in the Windows Hardware category; Trying to install NT4. 0 on a Dell PC (160GB serial ATA Drive). Have successfully installed W2k & XP Pro. When running NT4 setup, it does not see the hard disk. Have hit f6 key during install which allows setup to continue but when PC restarts setup fails.
Trying to install NT4.0 on a Dell PC (160GB serial ATA Drive). Have successfully installed W2k & XP Pro. When running NT4 setup, it does not see the hard disk. Have hit f6 key during install which allows setup to continue but when PC restarts setup fails. Have installed Virtual PC 2004 on XP Pro & tried to install NT4.0 but again same results as above......HELP! ;(
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Dec 17
Dec 23
0
1 minute
Responses to this topic
Either the NT4 driver is underdeveloped or unsuitable for your setup. Best stick with old fashioned Parallel ATA drives for NT4.
