Trying to set up my new PC with RAID 0... help!

Okay, here's the deal: I just got my system in, Athlon64 3000+ on a Chaintech nForce3 mobo (the one reviewed here). I installed my DVD burner on IDE1, and IDE0 is left empty. I have two SATA drives, Seagate 160GBers.

Windows Hardware 9627 This topic was started by ,


data/avatar/default/avatar15.webp

2 Posts
Location -
Joined 2004-06-08
Okay, here's the deal:
 
I just got my system in, Athlon64 3000+ on a Chaintech nForce3 mobo (the one reviewed here).
 
I installed my DVD burner on IDE1, and IDE0 is left empty. I have two SATA drives, Seagate 160GBers. Using the RAID utility I created a 298GB RAID0 array, and set bootable = yes.
 
Fast forward .... I use the Windows XP CD and boot off it. I use the floppy to install the RAID drivers. However here's my first question: Does RAID 0 come up as one drive or two to Windows? Because in my configuration, there are two drives listed. However, it lists them on the same ID:
"152626MB Disk 0 at ID 0 on atapi [MBR]"
"152626MB Disk 0 at ID 0 on atapi [MBR]"
 
So I'm GUESSING that it's picking my RAID0 array up properly?
 
Also in my BIOS... what should I have my second boot device set as? I tried to see if I could set it as my RAID controller but it's not listed, so I set it up with HDD-0, but unfortunately the PC won't boot off that.
 
Any help you can give I'd appreciate.

Participate on our website and join the conversation

You have already an account on our website? Use the link below to login.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This topic is archived. New comments cannot be posted and votes cannot be cast.