usb on dfi lanparty nf4 ultra

This is a discussion about usb on dfi lanparty nf4 ultra in the Windows Hardware category; None of my usb ports seem to work. Every device I hook up I get a device cannot be recognized error. I have a 400 watt power supply. Could it be there isn't enough power. The motherboard is a dfi lanparty nf4 ultra.

Windows Hardware 9627 This topic was started by , . Last reply by ,


data/avatar/default/avatar21.webp

2 Posts
Location -
Joined 2005-03-02
None of my usb ports seem to work. Every device I hook up I get a "device cannot be recognized error". I have a 400 watt power supply. Could it be there isn't enough power. The motherboard is a dfi lanparty nf4 ultra. Any help would be appreciated thank you.

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This subject has been archived. New comments and votes cannot be submitted.
Mar 2
Created
Mar 11
Last Response
0
Likes
2 minutes
Read Time
User User User User
Users

Responses to this topic


data/avatar/default/avatar09.webp

1019 Posts
Location -
Joined 2004-12-21
Is the usb controller enabled in BIOS?
Does the windows have drivers installed for it?
 

Quote:...
400 watt power supply. Could it be there isn't enough power
...

That should be enough.
 

data/avatar/default/avatar21.webp

2 Posts
Location -
Joined 2005-03-02
OP
The drivers are installed and for usb and it is enabled in the bios.

data/avatar/default/avatar33.webp

3 Posts
Location -
Joined 2005-03-11
I have the same problem on my DFI LANparty NF4 SLI-DR.
 
If i have a usb device in at startup it freezes at the post screen.
 
If i try fitting any in windows i get "device cannot be recognized error"
 
Any help is greatly appreciated.
 
Andy

data/avatar/default/avatar33.webp

3 Posts
Location -
Joined 2005-03-11
It's not a windows XP usb problem, but a problem with the DFI lanparty board's usb.
 
An official DFI technician emailed me this answer -
 
Sir I have referred similar incident to engineering of DFI in Taiwan and they are working to determine what resolution is required. No concrete word at this time. Thank you for contacting tech support.

data/avatar/default/avatar33.webp

3 Posts
Location -
Joined 2005-03-11
I actually just fixed mine, by changing the boot order, i didn't have removable in there, i had the 3rd boot device disabled lol