Via 4in1 1.26 Ultra ATA controller problem?
When i installed the new Via 4in1 drivers in win2kpro, the drivers install some Via Ultra ATA controller drivers that replace the win2k ones for my MOBO. Everything works fine and looks good under device manager.
When i installed the new Via 4in1 drivers in win2kpro, the drivers install some Via Ultra ATA controller drivers that replace the win2k ones for my MOBO. Everything works fine and looks good under device manager...but you see, i got my dvd-rom and yamaha burner on one channel and when i try to burn, i get an error message saying the media could not be created or something and burning fails...if i uninstall the drivers for the IDE channels...i can burn again without any problems...anyone more had this problem?
---------------
Dual P3 600Mhz on 133Mhz bus (coppermine)
256Mb PC133
3D Prophet Geforce 256
Promisse ULTRA ATA100
SBLive 1024!
3Com 10/100 Network adapter
Dxr3 Mpeg card
WinTV PCI
one 60Gb Deskstar IBM
one 27Gb deskstar IBM
one 46gb deskstar IBM
Yamaha 8/4/24
Aopen 10/40 DVDrom
---------------
Dual P3 600Mhz on 133Mhz bus (coppermine)
256Mb PC133
3D Prophet Geforce 256
Promisse ULTRA ATA100
SBLive 1024!
3Com 10/100 Network adapter
Dxr3 Mpeg card
WinTV PCI
one 60Gb Deskstar IBM
one 27Gb deskstar IBM
one 46gb deskstar IBM
Yamaha 8/4/24
Aopen 10/40 DVDrom
Participate on our website and join the conversation
This topic is archived. New comments cannot be posted and votes cannot be cast.
Responses to this topic
Same problem here. One of my HDs wouldn't run in UDMA mode, so I installed the new, apparently beta, drivers. When I went to use Nero, same thing, so now I'm back to the old drivers with one HD in PIO mode. Oh, well. Anyway, here's a link to the topic on the hardware board:
Via BM driver 580_3011 affects CD writer software.
[ December 31, 2000: Message edited by: Qun Mang ]
Via BM driver 580_3011 affects CD writer software.
[ December 31, 2000: Message edited by: Qun Mang ]
